Design and Analysis of Bearing assembly in Knuckle steering using sensor

Abstract

This project work will be done in the academic area of “Bearing pressing on the knuckles”. The prime focus will be on introducing Error proofing in steering knuckle and Bearing assembly to ensure the pressing of ABS bearing on ABS knuckle and Non ABS bearing on Non ABS knuckle. The difference between ABS and Non ABS knuckle is both the part is common but one additional hole will be there in the ABS knuckle, in the same way difference between ABS and Non ABS bearing is both the part is similar but Magnetic strip will be there in the ABS bearing. The requirement is ABS bearing should be pressed in the ABS knuckle and Non ABS bearing should be pressed in the Non ABS knuckle. During pressing there will be a chance of wrong assembly of Non ABS Bearing in to ABS knuckle or ABS Bearing in to Non ABS knuckle. The major impact is ABS sensor will not work if Non ABS bearing pressed in ABS knuckle. If the ABS bearing pressed in Non-ABS knuckle then there will not be any problem but there will a loss because bearing cost is high when compare to Non ABS Bearing. The main aim of the project is to overcome the manual error during the assembly of steering knuckle and bearing.